If your brakes are squeaking you need new pads. You already knew that of course. But what if your steering wheel shakes during braking? You need new pads and rotors. Your wheel is shaking because your rotors are warped or otherwise worn. That’s what’s happening in this ’99 Prelude so…

Today I’ll be replacing a starter in a 2004 Honda Accord V6 (7th generation 2003–2007). Replacing a starter is largely the same in most cars but I’ll include specific information like bolt sizes and locations for this car. As always, I’ll include affiliate links to the tools I used. The…

You did it! You made the decision to bring your 90’s Honda into the 21st century with a digital dash from Link or AiM but… how do you mount it? This guide will show you step by step how to modify your factory gauge cluster to accept your shiny new…

Today is the day! The engine I’ve been building is going in the autocross CRX! I’ll go through the whole project step by step. To read about the engine build itself check out this post. Step 1: Have a friend who has a lift.

This is going be a long one. You and I are going to start-to-finish build a 1.8 liter Honda B-series engine for 500hp. The block we’ll be using is from a B18A1 which is a 1.8 liter 4 cylinder that came in 90–93 non-VTEC Acura Integras. It originally made 130hp.

Today’s project is installing this 42" LED light bar by Nilight (for off-road use) on my 2001 Honda CR-V. …

In this guide I’ll be upgrading a Honda B20B engine (from a JDM CRV) in a 1991 CRX Si to coil-on-plug. This method will be largely the same if you have a D, H or F series Honda engines. In the 90s cars used a mechanical distributor to send high…

So the check engine light came on in your car? Don’t ignore it! This calls for an OBD scanner. You can read the codes yourself with this tool or you can stop by an auto parts store and use theirs (for free in most cases).

This is the third post about my turbo CR-V. The can read about the original build and installing boost and air/fuel gauges. Today I’ll be doing some metal fabrication to add a “dump tube” to the CRV’s turbo wastegate. This is my first project with my new welder. …